FreePhone: 0800 H20 TIGHT / 0800 426 844
Waterproofing Products Ideal for the New Zealand Environment - HOME
- Contact Us
- Introduction
- Frequently Asked Questions
- Product Application
- Approved Applicators
- BRANZ Appraised
- Specification
- Guarantee
- View Products....
- Flexi-Seal® Nail n' Screw Patch
- Sikasil® C Bondbreaker
- Sikaflex® IIFC Joint Sealant / Adhesive
- Sika® PEF Rod
- Flexi-Seal® Deck Joint Reinforcing Tape
- Flexi-Seal® Reinforcing Bandage
- Flexi-Seal® Sealer Primer
- Flexi-Seal® Mega Prime
- Flexi-Seal® 2-Part Liquid Waterproofing Membrane
- Flexi-Seal® Positive Pressure Coat
- Butylseal - Flexible Butyl Rubber Tape
- Flexi-Seal® P.U.D. Waterproofing Membrane
Flexi-Seal® Positive Pressure Coat
A Waterproofing Compound
Flexi-Seal Positive Pressure Coat is a 2 part water based epoxy sealer, used to protect substrates such as masonry walls and concrete floors from dampness and water seepage through external ingress.
It is suitable for both indoor and outdoor applications, and compatible with Flexi-Seal 2 Part Liquid Membrane
Protect substrates from
dampness and water seepage
through external ingress!
| Typical Properties | |
| Resin Base: | |
| Appearance | Grey Liquid |
| Base | Epoxy resin |
| Solids | 67% |
| Viscosity (mixed) | 100000 cps |
| Specific Gravity | 1.50 |
| Hardener | |
| Appearance | White Liquid |
| Base | Polyamine adduct |
| Solids | 59% |
| Viscosity (mixed) | 10,000 cps |
| Specific Gravity | 1.46 |
| Mixing | 1:1 by weight or volume |
| Application Rate | 1st Coat = 3.0 sq metres/L (approx 140u dft) 2nd coat = 5.0 sq metres/L (approx 85u dft) |
| Final Finish | Matt |
| Touch Dry | 6 hours |
| Hard Cure | 12 hours @ 20 degrees C |
| Full Cure | 28 days |
| Curing Temp | > 8 degrees C -8 |
| Permeance | 0.37 x 10 gPa.s.sq metre |
| ASTM | E96094:Section 12(water method) |
| Potability | Conforms AS/NZS4020-1999 |
| Performance | Good adhesion to all common building substrates |
Resistant to oil, petrol, common soils, staining and detergent cleaners once cured.
Suitable for both indoor and outdoor use
Not recommended for:
- Contact with aggressive solvents, strong acid or alkali
- Use over untreated steel
- Use over areas where there is continuos water seepage within 72 hours of application
- Use where the ambient concrete slab temperature is below 10 degrees celcius
- Sealing cracks in concrete floors. Use Flexi-Seal 2 Part Liquid Membrane with reinforcing tape for this purpose.
Material Safety Data Sheet available on request
| FreePhone: | 0800 H20 TIGHT / 0800 426 844 |
Street Address: | 67 Dalgety Drive, Manukau City, New Zealand  |
Flexi-SEAL® Waterproofing System
Flexi-SEAL® is the trademark of |
 |
| Phone: | +64 (9) 268 6970 | ||||
| Fax: | +64 (9) 268 6971 | Mailing Address: | PO Box 98 866, South Auckland Mail Centre, Auckland, New Zealand  |
||
| Email: | Enquiry Form |
› Links
Custom Search